Hootis

With prime95 running 15 min temp is 65c is that a safe temp?
got e6300 cpu oced to 3.0

g8m3rtag

you said you have a tuniq? why does your specs say stock?

and 65c is about 10 degrees too high.

do you have two instances of prime95 running? are you checking the temps with Intel TAT. i suggest downloading orthos and running it instead of prime95.

__________________

Hootis

Updated profile- Temps are to high. Where do I go from here?
E6300 at 3gh, temps are 46c at idle and 65c at load.
On another note, GPU temps are 51c idle and 75c at load.
This is my first overclock. What the heck am I doing wrong???

Hootis

bump

g8m3rtag

change your FSB to 400. (total ghz =2.8) that should get you better benches cause of the higher north bridge strap that kicks in at 401+ FSB. should lower your temps too. the gpu temps are fine, there usually real high like that.

edit: dont bump unless its been 24 hours

__________________

Hootis

ok lowered FSB to 400 droped vcore to 1.35 and idle temp is CPU0 30c CPU1 32c what temp should i aim for with this setup?

g8m3rtag

well what is it under load?

__________________

Hootis

cpu0 44c cpu1 45c orthos 4 min

im_not_an_artard

load below 55c, but your temps shouldn't be that high w/ that cooler, how much AS5 or other thermal compound did you put on, it should be bout 1/2-1 grain of rice size, i'd try reseating ur tuniq, also make sure your ram is set to the correct timings, go into cpu configuration i think, then look at northbridge options

Edit: that 45c aint too bad

__________________
Arctic TT Armor Work Log
e6300 100% OC 1.49v 532mhz FSB - Crucial Ballistix 1:1 4-4-4-8
MASSIVE SALE - SONY HD CAMCORDER - GAMES - 2x1GB LAPTOP RAM

Hootis

used about that much maby a little less