phatman81

OK. I got it stable and did the video as well to see where i am standing before i add RAID, install, and call it done (for now at least).
Anyone see room for inprovement? (is that a good 3DMark and Super PI score?)

darkhider - Try theese settings, 4.2 was not stable, but 4.1 was...

Memory - Unlinked and set to 1066.
set to 2.1V, timings 5-5-5-15-22-2T
FSB - set @ 1.3V
vcore - set @ 1.45 but vdroop is 1.38V
SPP - the auto setting placed it at 1.4V

*There is 4GB RAM, but using XP 32-bit. Does anyone know if 64-bit will raise the scores at all?*


Screenshot of Scores and Verification

Also, How do i do attched thumbnails?

__________________
CPU-Z Validation(4.1GHz) :: GPU-Z Validation Card1 :: GPU-Z Validation Card2 :: Screenshot of Scores and Verification

darkhider

I'm not sure what is 22? Where does 22 go under for memory? I'm just using a different bios company so I only have the options that I have listed on last page.

wierdo124

You should be able to easily to 4GHz on an E0. I barely do it on my E8400 C0, E0s are much better.

__________________
Dig cars more than computers? Stop by CarForum.net!
E8400 C0 @ 4.3GHz on AIR
Quote by Syrillian: "Nono!...Kill person."
Windows 7||Fan Club The ß₤ứə Çřёώ The American Overclockers The Tux Club The Red Tide
Never Use Your Flash Drive the Same Again! Supercharge Vista!
[F@H]View Your Fahmon From Anywhere!
Member of Royal Navy GPU F@H Team

darkhider

http://www.overclock.net/intel-cpus/...t-3-85ghz.html

Okay, this is actually my thread but I am not able to figure out my voltages. I have a different bios which comes with EVGA 750i FTW mobo.

And on my bios, after 1.2v for FSB, it shows in red which probably means its harmful.

phatman81 said to change it to 1.3v but when I tried it, I think it crashes. It probably because it was red or something. So I want to know how I can use the voltages correctly.

flyin15sec

SEE your thread.

ipod4ever

Your Vcore is way to high for that chip.

__________________

Q9650 Club

I FOLD FOR OCN..

darkhider

So how much should I set up the vcore to then?

phatman81

i must appologize for my previous post. as others have stated, that voltage is too high. where ever i got my info from, it was wrong. I have since changed it to a voltage under 1.36V and have actually been able to overclock to a better GHz. I also did the Vmod, which definately helped to stablize the Vdroop. I did go a bit overboard unknowingly and now get a 0.015 increase nder load. I dont mind this since i can drop the idle voltage and it will turn it up a notch when it needs it. ill have my new stable settings up soon...

__________________
CPU-Z Validation(4.1GHz) :: GPU-Z Validation Card1 :: GPU-Z Validation Card2 :: Screenshot of Scores and Verification