Overclocking q6600 + gigabyte GA-EP35-DS3L - Page 2 - Overclock.net

BlakHart · 02-20-09

Set FSB to 400 and set DRAM to 2.00 D.

and as far as memory timing go it depends on what RAM you get... you'll have to increast voltage on the RAM too if you want to OC it a little.

BradleyW · 02-20-09

DRAM to 2.00D. And thats all i have to do? set it to 2.0? where abouts will that setting be located or is it located within the 2.0D?

or have i got this all wrong and missunderstood?

BlakHart · 02-20-09

It's all in the BIOS under MIT Intelligent tweaker.

Set Clock Ratio to 8

Enable CPU Host Clock Control

Set CPU Host Frequency to 400Mhz

Set PCI Frequency to 100Mhz

Disable C.I.A.2

Set System Memory Multiplier to 2.00 D (That will give you a 1:1 assuming you're running DDR2)

To lower timings change DRAM timing selectable to (Manual) Use whatever timing work for you...I'm at 4-4-4-12

Then scroll down and change your voltages

CPU Voltage Control @ 1.41875

DDR2 Voltage @ whatever you need...My RAM operated at 1.8 volts but could handle 2.1 so I upped DDR2 Voltage 0.3v to get 2.1

and that should be it.

BradleyW · 02-20-09

thanks so much, i will give rep. i will write all that down. what if i set it to multi of 9 but did all that stuff you told me? would that be better? if not, could i push it higher at multi of 8?

thanks so much for the detailed answers. you are all the best!!

BlakHart · 02-20-09

You can try 9, my gigabyte board doesn't like it...If you change it to 9 I'm not sure you can get a 1:1 ratio.

BradleyW · 02-20-09

hmmm, i will have to have a good play around then and try those settings you told me.
thanks for the advise, its great.. cheers!

BradleyW · 02-20-09

http://www.overclock.net/intel-mothe...ml#post5556321

on this thread, someone got there quad at 3.6ghz and multi of 9 and fsb of 400 and ratio 1 to 1 at a guess. i think i made a good choice for once with this pc lol. crysis here we come!