|
![]() |
Overclock.net - Overclocking.net > Intel > Intel - General | |
Unstable system....
|
||
![]() |
|
|
LinkBack | Thread Tools |
|
|
#1 (permalink) | ||||||||||||
|
PC Gamer
|
OK here is what is happening or was, i kept getting BSOD's about like 4 different ones most of them pointed to memory, so i took one stick out.... and ran WITHOUT BSOD's so i put the other back in but not in DUAL channel mode and ran Memtest i had 7 errors.... with not being that many i thought maybe its a Vcore and dram voltage issue, so i found what the manf of the CPU and Memory says it should be so i set it to that...all seems fine. But seems my systems freezes now, but after few seconds comes out of it and is fine. Here are my temps and volt
__________________cpu temp = 19c idle 27 load Cpu volt = 1.25 set manual Memory volt = 2.20 set manual any ideas why this might be happening? anyone think maybe i should put it back in dual channel since i set the Voltage to the correct spec? System is my system below, also all OC is off right now... all stock
Last edited by Kidem : 07-02-08 at 09:57 AM. |
||||||||||||
|
|
|
|
|
#2 (permalink) | |
|
You break it, I fix it
|
Quote:
__________________
"noobdown" just another OCN member helping noobs get up to speed Official Cooler Master 690 Club
|
|
|
|
|
|
#3 (permalink) | ||||||||||||
|
PC Gamer
|
ooops sorry meant " ran WITHOUT BSOD's" I corrected in org post
__________________
|
||||||||||||
|
|
|
|
|
#4 (permalink) | ||||||||||||
|
PC Gamer
|
Just FYI - My system seems stable now i change the Vcore and dram voltage to the specs by the manf.... Have had 0 BSODS and it seems to not freeze no mroe niether, played about 4 hours of COD4 last night and my cpu is even running alot cooler since i turn the vcore down to what it should be. IDLE - 17c Gameplay - 24c I keep my room temp at about 67 - 70 depends on the day :P So not bad for all stock cooling and 3 extra fans!!!!
__________________
|
||||||||||||
|
|
|
|
|
#5 (permalink) | |||||||||||||
|
First Time Build
|
Your computer is cooler than the room thats really good. Wish I could make mine that way hehehe.
__________________I would run memtest on each stick and find out which one is bad for sure and replace the bad one. Just me. Glad its not crashing right now on you.
|
|||||||||||||
|
|
|
|
|
#6 (permalink) | |||||||||||||
|
Overclocker in Training
|
I don't think 19/27c is accurate, that's too low
__________________
StarCraft player.
|
|||||||||||||
|
|
|
|
|
#7 (permalink) | ||||||||||||
|
PC Gamer
|
Bios says 17 at idle so does Smartfan and pcwizard. i do have a air duct going to CPU which covers it and a 80mm fan in the duct. My GPU idle is at 36c also and load i think 41-43 somewhere in there
__________________So am i doing something wrong getting temps?
Last edited by Kidem : 07-03-08 at 08:30 AM. |
||||||||||||
|
|
|
|
|
#8 (permalink) | |||||||||||||
|
Overclocker in Training
|
naw, the sensor is probably just off. On my previous motherboard I had similar problem, could never get the temps to detect properly. 20C is 68 Fahrenheit, room temperature. No way a powered on CPU can sit at that.
__________________
StarCraft player.
|
|||||||||||||
|
|
|
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|