ASUS P5N-E SLI 650i Thread

[pheoxs]

I think thats abit high, i have my e6400 o/c @ 3.0 ghz with this Mobo and I'm running 34C idle n 50C after Orthos for 6 hours. Is that 53C in ur second last post under a full load or is that your idle temp? if its your idle somethings definitely wrong, if its under load, its still a bit high. Whats your Vcore set at?

Edit: Also note I'm running stock cooling

[illwun11]

i got the same temps at idle while oc'ing and at factory specs so i'm not sure what it means.

[illwun11]

This is a screenshot of speedfan with my setup at stock specs which is pretty much exactly the same as it is when OC'd. See anything wrong with this picture?

[dpawl31]

Don't trust speedfan unless you have something to trust it against.
ie PC Probe II (came on motherboard CD)

Use that, and see what your temp is. I have a feeling your real temp is one of the first two in speed fan (temp1 or temp2)

[Kopi]

Yeah my case is silent too...i've been thinking of getting some different 120mm fans as the rear one is VERY loud at fullspeed. I have a controller, but i know there are some out there that pull like 60cfm at 20dba while this does 34cfm at 17dba....its quiet and then all of a sudden jumps to unbelievably loud. I have a front thunderblade which i love

[dpawl31]

My tricools run @ max 79CFM, but only 30dba

The 200mm is something retarded like 130CFM and 19dba...Cha-CHING!

[Kopi]

Score. These pull 95cfm at 45dba but i'd like a sort of in between.

[2dxtreme]

i need someone's help i don't mean to jump in here and raid this thread but i just got done installing everything in my new case go here http://www.overclock.net/intel-build...need-help.html for the build specs. well i fired it up for the first time and it won't post i just get check signal on my monitor what can i start checking to see what the problem is?

[dpawl31]

By the thead you posted, you have the P5N32-E SLI, not the P5N-E SLI which means you got the wrong thead here

Try this one : P5N32-E SLI Overclocking Guide

They should be able to help with your specific board

If it's not posting @ stock... check your RAM to see if it is seated, as well as everything else onboard. Check all jumpers, wires, etc. Could be anything.

Make sure you have all power connectors on the motherboard connected as well (24 pin plus extra 12v power)

[illwun11]

I oveclocked my C2D E6400 to 3.2ghz and these are the temp and voltage readings plus CPU-Z. Thanks A LOT to DPawl for helping me on my first OC. It's working beautifully.