Gigabyte GA-P35-DS3L Thread

[JLT_GTI]

Originally Posted by BradleyW

hey guys, my ds3l was smoking at the NB area so i put the hr-05 on the nb. what settings in the bios will get my 3ghz? cheers.

my vid is 1.26v but my vdroop is bad. if i need 1.3vcore, i have to set 1.4v. is everyone else the same?

Is the NB the area wich reads in speedfan "-Temp 2 , Chip: IT8718F , Sensor: temp2 , BUS: ISA , Adress: $290" ?

Orthos passed ok my 3,33Ghz setup but that sensor went up to 70ºC and i want to know what part of the mobo is and if its bad to have it going up to 70ºC (IE .. can my mobo die sudenly under heavy load?)

[BradleyW]

i think it might be, dont use speedfan tho, its a load of rubbish.

any siggestions on the settings.

[JLT_GTI]

Originally Posted by BradleyW

i think it might be, dont use speedfan tho, its a load of rubbish.

any siggestions on the settings.

Everest reads the same temp and it reads it as "motherboard" simply.. i asume its the NB.. the thing is.. how much temp can the NB take?

[BradleyW]

mine set on fire at 55c

[JLT_GTI]

Originally Posted by BradleyW

mine set on fire at 55c

LOL.. and mine reached 70ºC... and now im even more disorientated since in a thread here about the P45 NB people say it can take up to 110ºC with 90ºC oced easy.


thread: http://forums.tweaktown.com/f69/ga-e...erature-30357/

[SgtSpike]

No idea how hot the NB can go before it has trouble. Mine runs about 60c at the current OC of 450mhz FSB with +.1v FSB and +.1vMCH. Been running for at least a year that way, and no problems yet. That's the best I can tell ya.

Oh, and you're right, temp 2 in speedfan is the NB for this motherboard.

[rammunition]

ok, i have a question, can i flash the mobo bios using Qflash and is it safe? also how long does it take.

[nod32]

I believe Qflash is the safest way because you do it outside of the o/s. It only takes a couple of seconds.

[halifax1]

QFlash is the only way I flash the BIOS. I load the file on my USB drive, reboot, load up the BIOS then press F8 to load QFlash, then choose the drive, then the file, it'll read the file, then flash it, then verify, and all done.

Took maybe 15 seconds.

I flash it a few times just to be sure a proper flash happens, because the first time I flashed I had all sorts of problems.

[Redmist]

How exactly do I tell if I have the Rev. 1.0 or Rev. 2.0?

CPU-Z says

Manufacturer: Gigabyte Technology Co., Ltd. 
Model: P35-DS3L x.x 
Rev.: A2

A2 = Rev. 2.0?