DFI Lanparty DK P35-T2RS Thread

[rsfkevski]

Originally Posted by Zakster

yes i do, works fine, easily overclocked to 4.3 not really put any effort in pushing further.

What were your settings? If I reset the CMOS and boot into Bios, my CPU registers 1.08v, but after I Load CMOS from saved bank (no voltage increases at all) it then shows 1.29v....***???????????????

[bluedevil]

Originally Posted by rsfkevski

What were your settings? If I reset the CMOS and boot into Bios, my CPU registers 1.08v, but after I Load CMOS from saved bank (no voltage increases at all) it then shows 1.29v....***???????????????

Yeah I'd like to know his settings too.......*must resist getting new mobo*

[rsfkevski]

Originally Posted by bluedevil

Yeah I'd like to know his settings too.......*must resist getting new mobo*

Are you having the same issues with the voltages as I am Blue?

[bluedevil]

Originally Posted by rsfkevski

Are you having the same issues with the voltages as I am Blue?

It's like I just hit a huge wall at 4Ghz (471x8.5). No matter what I throw at it voltage wise, it will not be stable at any higher frequencies.

[rsfkevski]

Originally Posted by bluedevil

It's like I just hit a huge wall at 4Ghz (471x8.5). No matter what I throw at it voltage wise, it will not be stable at any higher frequencies.

I was refering to VID's....but it's probably just the Q9650 E0 CPU's

I can't even get to those speeds

[bluedevil]

Originally Posted by rsfkevski

I was refering to VID's....but it's probably just the Q9650 E0 CPU's

Oh....yeah I have no issues with my VID..... 1.1125 is the lowest one I have ever seen for a Q9550 E0. I just want to unleash the beast inside.

[rsfkevski]

Which Bios are you using Blue?

Also, has anyone else had any good news or bad news with their 45nm Quad Core CPU's and this mobo?

I'm at a loss in reference to this VID thing, cause I'm 95% sure that this board is reading the VID incorrectly.

[bobfig]

ok i have my e8400 45nm not a quad but still may go with this. when i was overclocking and messing with a few settings there was one time that i ended having my VID being read as 1.12xxxv or something like that but changing it back it went to 1.25v. i forgot wat it was but was kinda cool. i was also reading the vid in real temp

[rsfkevski]

Originally Posted by bobfig

ok i have my e8400 45nm not a quad but still may go with this. when i was overclocking and messing with a few settings there was one time that i ended having my VID being read as 1.12xxxv or something like that but changing it back it went to 1.25v. i forgot wat it was but was kinda cool. i was also reading the vid in real temp

I don't know....I just increase my Vcore by +.050v and CPU-Z is reading 1.344v, so I don't have a clue what is correct. I'll upload a screenshot for your enjoyment

[bobfig]

all i know is that i got my e8400 to 4ghz with a vcore of 1.38 and drops on load to 1.36

BTW: dont trust speedfan on that stuff. try HWmoniter, realtemp or core temp

http://www.cpuid.com/hwmonitor.php
http://www.techpowerup.com/realtemp/
http://www.alcpu.com/CoreTemp/