Robilar

It fits fine with the TRUE and first slot. There is about 3mm of clearance to the clips

Attached Thumbnails

 

ipod4ever

I had to mount my zalman 9700 mount backwards so it would fit.

__________________

Q9650 Club

I FOLD FOR OCN..

ssinger1485

I had no issues mounting my zalman

ipod4ever

well it worked so yea

__________________

Q9650 Club

I FOLD FOR OCN..

Aardobard

Thanks for helping me check. Without better information, I decided to go ahead and take it off the mobo connector and run it from a molex adapter.

__________________
I got all my rep the old fashioned way. If you rep'd me and haven't received payment, rest assured, "the check is in the mail".

http://valid.canardpc.com/show_oc.php?id=485448

"What are the facts? Again and again and again - what are the facts? Shun wishful thinking, ignore divine revelation, forget what 'the stars foretell,' avoid opinion, care not what the neighbors think, never mind the unguessable 'verdict of history' - what are the facts, and to how many decimal places? You pilot always into an unknown future; facts are your only clue. Get the facts!"
- Lazarus Long

error10

I bet your temperatures are horrible. That's usually what happens when this Zalman is mounted backwards.

__________________
The Ice Stone has melted!

I did error10's Windows Challenge and I now am an MCSE: Minesweeper Consultant and Solitaire Expert!

oobe

+1, i tried this with my 9700 on my E6600 and had horrible temps, immediately switched it back around.

__________________
CPU-Z Validation

ipod4ever

I 300% disagree with you, Im running 2xsmp clients and these temps are on load



Heres real temp as well..




Ohh and btw I said I mounted the Mount backwards.

__________________

Q9650 Club

I FOLD FOR OCN..

scupkin

I just tried 350x8 and 1.4v but it would not work. The system ended up turning itself off then on three times before booting into windows with the old settings. It's like this processor can't pass 2.7Ghz. How do I get my system to run at 1 to 1 ratio and what else do I need to set? Also is it normal for these boards to turn the system off then back on a few times if the overclock doesn't work?

Ghostleader

It´s normal for this board and it´s probably because it´s not comfortable with your ram setup, due to strap, ram multi, static read value, ram volt, MCH volt, MCH ref or CPU.


Set MCH Frequency Latch to 400MHz and System Memory Multipler to 2.00D, now you have 1:1.

Time to do some trail and error with your setup.

__________________

Asus Rampage Extreme Overclocking Guide

Running SLI on a Rampage Formula

Running SLI on a Rampage Extreme

Test Rig