Bazmecc

yah, that's the newest for v1.6 from Gigagyte's site

__________________
3DMark's 01 62438 | 03 57405 | 05 23830 | 06 18879 | Vantage P11491

XtremeCuztoms

well, gotta be up in 3 hrs. gonna be a long day tomorrow. thx for the help thus far and i hope i can resolve.

XTC

__________________

radioman81

Yes, my VID is 1.3 (accoridng to coretemp). My RAM is 1.8 or 1.85V (low voltage OCZ Blade 1200).

Right now it runs stable on Vcore 1.47 / DDR 2.18 @ 4.2 GHz (467 x 9.0)

dennyb

When you load Optimal Defaults the USB devices will not work until you go into the BIOS ( Int Peripherals) and enable all of them. Always perform CMOS reset and Load Op Def in this way

CLEAR CMOS
Shut down--unplug-- hold start button in for 10 sec--short the CMOS pins in lower right corner of mobo for 1 minute using a flat screwdriver--plug back in-start--

Load Optimum Defaults--Set PCIe to 100--Set ram timings-- setDRAM voltage--go to Integrated Peripherals-enable all USB settings(they are at the bottom of the page)--go to Advanced BIOS Features,init display-select PEG
Also the boot order will need attention

__________________

DaClownie

Nice job, radio.

Keep up the good work! If your temps are staying low, keep on tweaking it... you might be able to push 4.5ghz?

+rep!

dennyb

I would not run my Ram past manu Voltage specs unless for high benching purposes. I don't think 4.5GHz is in the cards as daclownie has suggested. I cant get that high stable on my 1.25 vid chip and yours is higher than mine. Some of the low vid chips like Radaja and Sergio have will do it but they are rare.
I like 4.0 GHz for a 24/7 clock. Low volts and plenty of speed. Seems to be the sweet spot for me.

Edit: ACHILLEE5 has a 1.3 vid chip @ 4100 I think,so when he checks in he can give you some #s to run that speed stable

__________________

repo_man

Figured I would make this post here since everyone wants or has this board,lol. I have a UD3R for sale now. I've been using it with my e6750 and it will do 500+ fsb.

__________________



Current Projects --Sanguineus Cinis Cineris
Completed Build Log's -- Hinges for Syrillian's Silentium // Project: Phoenix // Flip this Tower

radioman81

Ok, it look like that for now I can stablilize my CPU at 4.3 GHz with the following settings:

CPU Vid is 1.3

Core settings...
CPU VCore: 1.47V
DDR 1.84V @ (max manu spec is 1.85v)


So far, memtest without any errors - we will see...
Keep you posted after the prime95 test ran a bit

Dilyn

Dude if it was a UD3P I'd totally look into it. Need some dual PCIe slots

__________________

slushmad

yay!! so i just ran prime. it ran for 12 hours or so no error! I had to up vcore to 1.376 (windows) and temps get up to 75. I'm happy with the results but would you guys say I should drop it down to 4.4, I think I can do 4.4 with 1.35v. Super happy I reached my 4.5 goal!! Thanks for the help and pointers