CPUcorespeed: 3.3 GHz
load_temperature: 60 Celsius
idle_temperature: 15 Celsius
manufacturer: intel
corespeed: 3.3 GHz
RAMsize: 4 GBytes
speed: 1600
size: 4 GBytes
count: 2
channels: dual
speed: 1600
voltage: 1.5 V
Hard Drivecapacity: 240 GBytes
count: 1
capacity: 240 GBytes
count: 1
Comment: For a sandforce drive, it's pretty damn fast. CoolingComment: Purchased a .5" thick piece of copper (originally 12x6x0.5") from McMasterCarr and went to work. The block was... more CoolingComment: Cooling single HD 6850, which is a bit overkill, but I wanted it future proof. This should be a solid GPU only radiator f... more | CoolingComment: I've had extremely good temps with this little guy. Enough so that it warranted creating some custom mounting brackets so I could utilize it on ANY motherboard socket. CoolingComment: My first watercooling solution was a Rev1 Koolance Exos. I still use the pump and controller board for the chilled CPU lo... more CoolingComment: This is pumping the peltier hot side water from the heat exchanger to the radiator. I've been very pleased with this pump, so far. PowerComment: This doesn't have quite as low DC ripple as I'd like, but it's been a great PSU. | Graphicsmemoryclock: 1100 MHz
coreclock: 800 MHz
memory: 2 GBytes
memoryclock: 1100 MHz
coreclock: 800 MHz
manufacturer: nvidia
memory: 2 GBytes
Hard Drivecapacity: 1 TBytes
count: 2
raid: 1
capacity: 1 TBytes
count: 2
raid: 1
Comment: These don't seem quite as responsive as my HD502HJ's did in Raid0, but I needed more space. CoolingComment: Using peltiers, controller card, and the nice blue anodized aluminum water blocks only from the original unit. CoolingComment: Radiator to cool hot side of peltiers. Push/pull config with 2500k RPM fans, although I typically only need 2 pull fans r... more Casecase_temperature: 75 Fahrenheit
|
Comments (0)