xXDarkenSoulXx

Ok. Just did the a antenna mod on my Buffalo G300N. This is only happening on my desktop which has a n card. I cannot access my router, see other computers on the network, or go on the internet from that computer. But I could connect to the access point. I could see my desktop on the network from my other computers, btw.

The router is running dd-wrt and all other devices could connect to it.

I get a "The connection between your access point, router, or cable modem and the Internet is broke" from windows network diagnostics.

Thanks for the help.


Edit:It just started working again out of no where! Will post back if there are any changes

__________________

reezin14

Does win 7 have a repair feature like vista?If so try that.Are you getting an ip address(ipconfig/all).Can you ping the AP.

__________________
Q6600@3.9
http://valid.x86-secret.com/show_oc.php?id=383427

xXDarkenSoulXx

Yea, I was getting a ip address (192.168.1.1), but I couldn't ping it. Now I'm trying to figure out why I this happened before.

This is weird, but when it wasn't working before, I was getting 4 bars, now that it works, I'm getting 2 bars and it is preforming sluggish.

__________________

reezin14

Is the ip address 192.168.1.1 your router's ip(I assume) or your pc's ip?Check device manager to see if there is a problem with your wireless nic.And try rebooting your pc.

__________________
Q6600@3.9
http://valid.x86-secret.com/show_oc.php?id=383427

xXDarkenSoulXx

192.168.1.1 is my routers ip, and I just reinstalled windows, so it narrows the problem down to the router. Could it be the mode the router is operating on? Because when I get 2 bars I get a connection and when I get 4 bars I don't.

__________________