asavage890

apologies if im going over old ground for some..........
is it viable to connect freezone to a complete water setup.

freezone>gpu>rad>res>pump>cpu>freezone....or something like that?

__________________
http://img237.imageshack.us/img237/4167/pi11969sa9.png

bullcrew

Id think so, The tecs are on the radistor anywase not hte CPU.

Just trade in and get up to 30% off a new system from them. They are launching the new stuff and offering it as an incentive.

__________________
3DMARK06 13882
http://service.futuremark.com/compare?3dm06=3365267
Pi 1M 14 sec Pi 32m 14.43.
ROCKIN A Coolit FREEZONE ELITE!

ChielScape

yes, but use splitters before you push the water trough the TECs. they use smaller diameters (1/4") than your loop (1/2" probably). this will hurt flow less. and you should make it CPU>GPU>Res>Pump>Rad>Freezone>CPU

__________________
Bigger = better, except for transistor size.
480GTX Club

asavage890

nice1...going into area i know nothing about so thanks for positive response and setup advice....rep
if i had my nb in there where in that setup would it be 'cpu>nb>gpu'?

__________________
http://img237.imageshack.us/img237/4167/pi11969sa9.png

strangesnow

How did it go? I'm tempted to do the same thing, maybe even go to a fanless rad like the reserator 2 for silent operation. that way when I juice up the system i can get great performance at a lower noise level.

I've modded the freezone already to take a 140mm fan and it is significantly quieter without much less performance...

asavage890

it didn't go...........i bought a vapochill...sold my coolit...vapo didn't arrive! back to water!!!!!!!!!

__________________
http://img237.imageshack.us/img237/4167/pi11969sa9.png