Burn

http://www.performance-pcs.com/catal...oducts_id=3204

Using that with my PCP&C, will I have any issues? Will go into a P5B-Deluxe or a Commando.

__________________
My CNC Mill Project
We cannot change the cards we are dealt, just how we play the hand.
--Randy Pausch

pauldovi

Give PC Power and Cooling an email. They are very nice and respond within a few hours! They will know the answer!

http://www.performance-pcs.com/catal...age=contact_us

P.S. - I have to say the Commando looks sexy....

__________________

FlaKing

Nope. I used one with my SLI-DR Expert for a while. Worked fine.

Burn

From Bob Roark @ PCP&C:

"We really do not recommend stepping the processor connector up like that,
but it will work."

Kind of vague, doesn't really give me a concrete answer...As in "Yes, it will work forever", or "No, it'll create a lot of stress on your PSU components....:\

Sent an email back to him a few days ago, we'll see what he says on Monday

Thanks everyone for the suggestions!

__________________
My CNC Mill Project
We cannot change the cards we are dealt, just how we play the hand.
--Randy Pausch

Burn

Solved my problem

Turns out my old OCZ Powerstream 520 is EPS12V certified. It's only got 2 SATA plugs though, so I am going run my 4 hard drives off molex connections. No problems there Installed my PCP&C as well, just in case I need some more power

OCZ did it weird, they made the ATX 20/4 brick modular, so you could do either 20 or 24 pins, so I am going to order a 24-pin ATX connection, as well as an EPS12V 8-pin connection because they did the same thing with the 8-pin connection, you could use it as a 4 or 8 pin connector. ACRyan's naming conventions suck though, they should be called "Male", when they name them female...I don't think I need to explain why

Thanks guys for all the help!

Edit- Decided not to install the PCP&C, I was going to use Lian-Li's PSU jumper cable thing to turn the PSU on when the other one went on, but it would look really messy and majorly ugly. So I will run the HDDs off molex connections and be happy

__________________
My CNC Mill Project
We cannot change the cards we are dealt, just how we play the hand.
--Randy Pausch

Burn

Okay, so much to my chagrin both the 20/24 pin connection and the 4/8-pin EPS12v connections are modular, as stated above. Here are some shots of the PSUs installed, that's a lot of cabling

Will order the two connections above to de-modular-ize them, and make installation much simpler.

Attached Thumbnails

         

__________________
My CNC Mill Project
We cannot change the cards we are dealt, just how we play the hand.
--Randy Pausch

FlaKing

Glad you're getting it sorted out. Its pretty cool that the WD drives are molex as well as SATA power. I didn't know that when I bought them.

Burn

Indeed! I hope I hear back from tankguys RE pricing, I wanna get started!

__________________
My CNC Mill Project
We cannot change the cards we are dealt, just how we play the hand.
--Randy Pausch