You know how those old timers like Skinee and MartinM are ALWAYS preaching about using good barbs and avoiding swivel based 45's and 90's ? I always thought they were a bit wonkey....
This build had butt load of them ..... and guess WHAT??
They were right !
Specifically THESE duckers:
See here: http://www.ultimatepccooling.com/fes...d-x-12-od.html
They ducking fittings bleed like little ducking pricks.
Swapped them out with straight barbs and problems GONE....
Not as sexxxxy to look at but once tubing is on you can't tell.
AVOID the Feser Angled compression fitting like the plague
...... The drip drip drip from the swivel base unless it is PERFECTLY perpendicular to the mounting.
Also: The Bitspower 90's have no issues at all ... All of them are as tight as a frogs butt without a single drip. http://www.frozencpu.com/products/88...HZMr&mv_pc=523Edited by ShtSh00ttr - 5/18/11 at 4:52pm