Earlier this morning I got a decent amount of work done. All I have left at this point is to actually figure out if I am going to use a dual loop or if I am going to just daisy chain the PMP-400s. I am leaning more towards the latter and putting the 6990+6970 on the 2 thick 360mm radiators and putting the processor and Northbridge on the Koolance 360mm rad.
Anyway here are some more pictures
The 6990 and 6970 right after having the EK block and back plates installed on them, I also got the single PCI bracket for the 6990.
Here is the the motherboard compartment. As you can see I have the PowerAdjust 2 mounted reverse, I have to find some of that carbon fiber lining to cover up the silver on the PowerAdjust 2 and the BluRay-RW. As you can see I have not gotten to doing anything with my loop, not even fittings on my hardware, heh.
And onto the last picture, the radiator/power supply compartment; it's nearly finished. Just missing one of the thick 360mm rads up top, some wire management clamps and hammond boxes which will have my 3-pin power cable splitters inside of them.