Originally Posted by spiderm0nkey
I don't know whether this stuff is Primochill or Feser. I think it might be the latter? It was sent to me at no cost to myself by a member of another forum who didn't want it at all. I don't think we can get the Primochill tubing you mentioned though.
MKHunt, I am planning to do both and have a switch to alternate between them. I have lots of white LED's to go in.
Tweaking for 4.1gHz stable atm.
Are you going to wire them to the case light switch?!
I was thinking of doing that w/ the cold cathodes + LEDs in the fans but I'd have to remove the fan pcb or dremel off the plastic and risk killing the fan. They're $19 USD each
Do you have any specific wiring diagrams or switch placements yet? I was going to adapt the switch diagram from the Storm Scout club but there's the fan problem. Also, not sure if the LEDs in fans are 12v like the fans or 5v on a different circuit.
ETA: Good luck with the OCing! I built my bestie a 955BE PC in 2009 and it hits a wall at 3.8. C2 chip. Also takes tons of volts and gets hotter than hell even with a Noctua UH9 cooler (megahalem clone) and 2 loons in P/P
I can sympathize on the hardships of OCing Phenom II.Edited by MKHunt - 8/14/11 at 11:55pm