Overclock.net › Forums › Intel › Intel CPUs › Help with Overclock
New Posts  All Forums:Forum Nav:

Help with Overclock

post #1 of 3
Thread Starter 
Not sure if this is the correct section couldn't find a "Help with new overclock section"

So i have decided to start from scratch and this time I am going to get it correct! below is the starting point that I am at:

My System Template



Components

Mother Board (EVGA x58 Classified E760)
Drivers (Mobo Drivers 9.1.2.1008)
Bios (EVGA version 82)
CPU (Intel Core I7 970@ 3.2 GHz)
CPU Cooler (Water Cooled with an EK Supreme waterblock for CPU)
Memory (OCZ Gold 6GB Budget RAM Kit PN - OCZ3G2000LV6GK)
PSU (Corsair AX 1200 Modular PSU)
GPU (EVGA Radeon 5970 Black Edition w/EK full coverage water block for 5970)
Drivers (11.7)
Operating System ( Windows 7 64 Ultimate )



Power Management Settings

ACPI function [ENABLED]
ACPI suspend type [S1 (POS)]
xrunvgabios if S3 RESUME AUTO
Soft off by power button [Instant-Off]
wake up by PCI card [ENABLED]
xUSB KB wake-up from S3 DISABLED
resume by alarm [DISABLED]
xdate(of month) alarm 0
xtime(hh:mm:ss) alarm 0 : 0 : 0
HPET support [ENABLED]
HPET mode [64-bit mode]
power on function [DISABLED]
xhot key power on CTRL-F1
PWRON after PWR-FAIL [OFF]

PNP/PCI CONFIGURATIONS

Init display first [PCI EX]
Reset configuration data [DISABLED]
Resources controlled by [AUTO(ESCD)]
xIRQ Resources Press Enter
PCI/VGA Palette snoop [DISABLED]
INT PIN 1 [AUTO]
INT PIN 2 [AUTO]
INT PIN 3 [AUTO]
INT PIN 4 [AUTO]
INT PIN 5 [AUTO]
INT PIN 6 [AUTO]
INT PIN 7 [AUTO]
INT PIN 8 [AUTO]
Reserved RC for bridge [DISABLED]


**PCI EXPRESS RELATIVE ITEMS**
Maximum payload size [128]

Frequency/Voltage Control

Dummy OC [DISABLED]
Extreme Cooling [DISABLED]
CPU clock ratio [24x]
CPU host frequency [133]
xTarget CPU frequency 3200Mhz (133x24)
xTarget Memory frequency 11067Mhz
MCH strap [AUTO]
CPU Uncore frequency (Mhz) [AUTO]
CPU Clock Skew [0PS]
IOH Clock Skew [0PS]
Spread Spectrum [DISABLED]
PCIE Frequency (Mhz) [100]
OC Recovery [DISABLED]
Turbo Performance [DISABLED]

EVGA VDROOP control [Without VDROOP]
CPU V CORE [AUTO] 1.10625V
CPU VTT VOLTAGE [AUTO] +0mv
CPU PLL VOLTAGE [AUTO] 1.800V
IOH PLL VCORE [AUTO] 1.800V
QPI PLL VCORE [AUTO] 1.100V
DIMM VOLTAGE [AUTO] 1.500V
DIMM DQ VREF [+0Mv] +0mv
IOH VCORE [AUTO] 1.100V
IOH/ICH I/O VOLTAGE [AUTO] 1.500V
ICH VCORE [AUTO] 1.100V
VTT PWM FREQUENCY [250MHz] 250MHz
CPU PWM FREQUENCY [800MHZ] 800MHz
CPU IMPEDANCE [AUTO] AUTO
QPI SIGNAL COMPENSATION [AUTO] AUTO

Memory Feature
Memory SPD [STANDARD]
Memory control setting [ENABLED]
Memory Frequency [AUTO]
xTarget memory frequency 1067Mhz
Channel Interleave Setting [6 way]
Rank interleave setting [4 way]
Memory low gap [AUTO]

Parameters Setting Current

tCL AUTO 07
tRCD AUTO 07
tRD AUTO 07
tRAS AUTO 18
tRFC AUTO 59
tREF AUTO 509
Command Rate AUTO 1T
tRRD AUTO 4
tRAW AUTO 20
tRTP AUTO 4
tWR AUTO 8
CH1 Round Trip Latency AUTO 44
CH2 Round Trip Latency AUTO 46
CH3 Round Trip Latency AUTO 46
Back to back CAS delay AUTO 0
tddWrTRd Setting AUTO 6
tdrWrTRd Setting AUTO 6
tsrWrTRd Setting AUTO 14
tddRdTWr Setting AUTO 9
tdrRdTWr Setting AUTO 9
tsrRdTWr Setting AUTO 9
tddRdTRd Setting AUTO 7
tdrRdTRd Setting AUTO 6
tsrRdTRd Setting AUTO 4
tddWrTWr Setting AUTO 7
tdrWrTWr Setting AUTO 7
tsrWrTWr Setting AUTO 4
tRL [+0]
tWL [+0]


CPU Feature

Intel Speedstep [DISABLED]
XTurbo Mode Function DISABLED
CxE Function [DISABLED]
Execute Disable Bit [ENABLED]
virtualization Technology [DISABLED]


xxxxxLogical Processor Settingxxxxx
Intel HT Technology [ENABLED]
Active Processor Cores [ALL]

xxxxxQPI Controller Settingsxxxxx
QPI Control Settings [ENABLED]
QPI Link Fast Mode [ENABLED]
QPI Frequency Selection [AUTO]


And of course the above is rock solid but it is NOT overclocked, so the target is to reach 4.5Gig stable AND with acceptable Temperatures!
post #2 of 3
I just typed a whole paragraph helping him and when I press enter well ERROR because the thread was moved. sorry bro you get help here.
post #3 of 3
Thread Starter 
OK thanks and sorry for posting in wrong section!
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Intel CPUs
Overclock.net › Forums › Intel › Intel CPUs › Help with Overclock