Originally Posted by superj1977
Edited my op.
How far back does that rad go? is it a 240mm?
If its a 240mm rad,is there room at the rear of case under PSU for a pump?
You could ditch your bay pump and install a pump and res under PSU at back of case to avoid running tubing in front of your window?
it's 60mm (rx360) plus i have push pull so it's significantly thicker... i have a mcp655 lying around somewhere, i'll try and find a place for it.
the back of my case is sort of crammed with hard drives and LED controllers... i guess i'll just try and take stuff out and find room
: sorry i misunderstood your post... it's 360mm so it goes all the way back to the hard drive bays
Originally Posted by GingerJohn
The way I see it you have two options:
1. Flip the rad as has been suggested or
2. Use some low profile 90Â° fittings like these
Either way increasing the length of the tubing slightly or adding a 90Â° fitting is not going to reduce performance by much, if at all.
not sure if the fittings will work, but i'll see if i can find some used ones cheap and try it out
thanks for the suggestionEdited by badatgames18 - 8/22/11 at 5:45pm