Originally Posted by unimatrixzero Klimaxx.. Today in a Few hours you will start fresh.. so here is what I suggest.
1. Totally disassemble the build. Motherboard out. Everything out. Drives. Hdd. Motherboard Ram, Video cards ... Everything, even the CPU. and cooler. Everything.
2. Now again.. check that black (motherboard Standoffs). Make sure you have all you need and none that you don't.
3. Get a Paper Clip. And put one side of paper clip into the Green wire plug and one in any of the black wire plugs to test you cpu. Plug your control panel to the psu and turn the psu on.. The psu should come on and test all your fans to make sure your fans and control panel is not shorted.
If your PSU comes on then your PSU is probably okay. If your fans come on then those are okay too.
Make sure you are very careful here.
a) First press in your back plate on all four corners to make sure that the Back plate is Set properly.
b). Now replace your CPU Processor into the Motherboard CPU Socket lga 1155. Make sure that you are very careful to align the CPU in the socket.
c). Now Put in only one Ram Stick. in the Second ram plug from Left to Right. That First one is B1
d). Plug in the CPU Fan. if you don't have a CPU Fan... Plug in the back fan into the the CPU Fan Plug. If there is no Fan Plugged into the Motherboard CPU plug then the Motherboard may show a Fault.
e). Now Mount the Motherboard onto one of the CENTER STAND OFFs and place a screw into it.
f). Now mount all the Screws carefully into motherboard. Hint. Don't tighten them down too tight. Just enough. And start from the Screws closest to the back of the case and work your way back.
g). Plug in your 8 pin PSU / CPU Plug. Then your 24 Pin Plug into the motherboard... No Paper clip needed now. LOL.7850 ATI GRAPHICS PLUG
a). Plug in the Graphics card. Make sure that it is plugged into the PCIe 1 slot.
b) Plug in the power cords that go to the back of the Graphics Card from the PSU. This is the step I always forget.PLUG IN YOUR SATA OS DRIVE / DVD DRIVE Only.
IF you need USB Plugs for OS install use the USB on the back panel for now.
a). Now.. plug in the Sata Power
connector and the Sata DATA PLUG into your SSD OS drive and plug it into one of the Top Sata Plugs on the board.
b). Then plug in the Sata power of your DVD drive and Sata DATA PLUG and plug it under the the data plug in the Main SSD Sata Plug.
Now you need to plug in your FRONT PANEL PIN OUT.