post #1 of 1
Thread Starter 
Hi all,

I have an Antec Kuhler 620 and two scythe slipstream case fans. I am running this in an Mini itx case so I need the scythe's thin fans to ahcieve my setup.

Unfortunately, the scythe fans have three pin and the connectors and the connector on the 620 pump is only 2 pin.... and therefore the fan does not start...

I am only assuming this is the reason, but i confirmed that the fans work by plugging them into the mobo. I confirmed the pump was getting power and working by plugging in the fan that came with it... both are working correctly.

If anyone can give me some advice on how I can get around this issue I would really appreciate it.


Thanks in advance,

Will

***UPDATE***

Hi again, I have just plugged a different 3 pin fan into the antec connector and it worked fine. the wires are in the same positions in both 3 pin fans.

The only difference I can see now is that the scythe fan is 0.25A and the other is 0.27A can this really stop it from running correctly?

Thanks again for any help

Will
Edited by will1990 - 10/7/11 at 11:25am