Update on the progress of the Case.
If done the window mod and changing the colour of the mesh
. I had to do the window mod twice, because I wan't really happy with the result of the first try.
I don't know why the red looks orange, but will try to get different lighting condition next time.
So how did I put the plexi in the place?
Step 1: Cut the plexi to the right shape leaving enough room to put some glue under it.
Step 2: Put the molding around the edges of the hole you cut.
Step 3: Put a "few" drops of glue (I used epoxy glue) around the hole
Step 4: Put the plexi on top of it and press it on a bit. Pay attention that you put the plexi as far as possible to the right as you can or else you cannot close the case anymore.
Step 5: Put a piece of on top of the plexi an clamp it down or you can use heavy thins to apply presure to it. My one had to rest for about 48h for the glue to fully dry. Keep in mind that this glue, when it dried is not hard, it has a rubbery tecture to it.
Step 6: Take the all the clumbs of and rip the second protection of the plexi and enjoy your new window mod