Redbull Fridge for PaxEast2012 *Updated 12-4 Fan & LED board HOW-TO* - Page 6

Just went over my 20GB bandwidth on Photobucket in 17days!!

Its a first for me and I just upgraded to PRO.



Thank you all for referring back to this build to inspiration as well as all the people who have subscribed.

Your correct! I was writing this guide off the top of my head while referring to the pictures to give everyone a general idea on what should look like what.
Ill fix the mistake

Thanks for the +REP!

Thanks, and yeah the contacts on the PCB look pointy due to my iron having a worn out tip. But DO NOT worry I bought a new tip and my fan solders as well as my LEDs will have a PRO look to it.
As for this board it should be fine since ill be covering the back with electrical tape then mounting it on that 3.5drive holder.

Thanks, but hes right. The professional soldering should not have any pointy leads.
More solder on an item actually creates a resistance in your line. Too many will prevent the right current going to your item that needed to be powered.

But being that its just low powered fans as well as LEDs(which take virtually no power at all) shouldn't be anything that noticeable.
But for powering motherboards/GPUs id deff would have done a cleaner job.

Would you believe me if I told you the entire loops will be cooled by RedBull? instead of distilled water.

It will not be cooled with actual Red Bull, but Ive always wanted that jager dispenser (goes for about $300 on their site).

Jagerbombs anyone?
I couldnt add a liquor company to my build since displaying it at PaxEast will also have underage kids attending and show casing Jagermiester isnt something im aiming for, But very clever!
When I get a bigger place im deff getting that machine!

Now only if it allowed three different loops inside that machine say
GreyGoose Jager and RedBull!!

Or Henny Jameson and JohnnyBlack