post #1 of 1
Thread Starter 
I bought this EK Waterblock Kit which comes with a DCP 4.0 Pump.

I have the loop as this : Res > Pump > Heatsink > Rad > Res

Now because of this loop, my pump has to sit in the bottom of the case as it needs to be lower than the Res.
The Pump has a 3 pin power connector, which I assume can control the speed of the pump if needed. Also in the kit, I found a cable that can extend the connector of the pump to a 4 pin fan header.

How do you suggest me to connect the pump, so that I can control the speed?

(Right now I have connected the cable to a 4 pin header , but that is unable to control the speed.)

Any help on this from the owners of this pump!!

Thanks in advance:)