Overclock.net › Forums › Intel › Intel - General › Help please!
New Posts  All Forums:Forum Nav:

Help please!

post #1 of 4
Thread Starter 
I have this config : Gigabyte GA-Z68X-UD3P-B3
Intel Core i7 2600K 3.40GHz
Gigabyte GeForce GTX 580 Super OC 1.53GB DDR5 384-bit
Corsair Vengeance 8GB DDR3 1866MHz CL9 -2 kits+16gb
Western Digital 1TB SATA-III 7200 rpm 64MB Caviar Black
Chieftec Nitro 88+ Series 1000W
Window 7 64bit sp1
I have one single problem with setting the memory to work at 1866..............so far it runs at 1333...........plese help step by step to set it up .
I am new with overclocking:D
post #2 of 4
probably not the right place to put this thread. Have you tried going into bios and setting the ram speed to 1866? Also if the ram and motherboard support xmp you might be able to enable xmp in the bios and then it should read the correct timings and speed for the ram
post #3 of 4
Thread Starter 
i have noticed to late that is the wrong place to post the thread...i will try to enabe xmp and see if it woks.thanks
post #4 of 4
no problem. If the xmp does not work try to manually set the speed. Normally it defaults to a lower speed so you dont want to use what the bios tells you. Depending on the motherboard it may not support 1866 but you should at least be able to knock it up to 1600 worst case
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Intel - General
Overclock.net › Forums › Intel › Intel - General › Help please!