Hmm I purchased Pro LRT a while back & when I took my loop apart I did notice that I had some residue. This explains a lot.. It also stained my XPSC Dual 5.25'' bay reservoir. I've tried to remove the white residue & was kind of successful using white vinegar + water + rice & shaking. I didn't leave the mix inside for too long because I was scared that the vinegar might start eating through my acrylic reservoir. Does anyone know of anyway to clean this out without harming my reservoir? There is still some stains & I don't want to reuse it unless its spotless. I'm going to try a baby bottle cleaner next.
I also purchased some Black Pro LRT for my little HTPC & have yet to take this apart, but I'll make sure to inspect it & see if there is any plasticizer problems once I do...
I'm actually in the process of ordering some new tubing. I was looking @ Primochill Advanced LRT
. Does this have the plasticizer problem?
Here is the rundown of my loop that I am currently building,
Alphacool XT45 180mm
Alphacool ST30 240mm
Alphacool ST30 120mm
Koolance GTX 590 Waterblock
XSPC Dual 5.25'' Bay for single D5
BitsPower Matte Black Fittings
What would you guys recommend for my additive? Silver coil, PT Nuke, or Mayhems Biocide Extreme? On Koolance's website, it mentions not to mix Silver & Nickle.. so I'm trying to avoid using a Silver Kill Coil.