Here is a nice stock picture from Corsair. I didn't get round to taking one myself as the case was already in bits seconds after pulling it out of the box 
Pulling it apart...
And the tubing I will be using. Standard tubing sleeved with steel braid with compressions to finish it off
Means I can use a nice tight bend radius without kinking and looks great too. This tubing is 7/16" ID by 1/2" OD.
Box full of braid from the scrap bin next-door to where my Dad works (thanks Dad).
Stuff that will be going inside.
Corsair HX750 PSU
Thermochill PA 120.2
2x Scythe Kaze 1900RPM for the rad
D-tek DB1 pump
Intel X25-M 160GB
Where I would like to place the radiator.
Top needs to be raised ~40mm.
The cheap fan controller included in the case front panel uses an LM317 adjustable linear regulator and a 3-way switch. Inefficient design, but it works fine and is actually better than I was expecting.
Here is what I plan for a reservoir in the side-panel. I will be making this out of acrylic or some similar material.
Edited by ARandomOWL - 1/14/12 at 12:36pm
Pulling it apart...
And the tubing I will be using. Standard tubing sleeved with steel braid with compressions to finish it off
Means I can use a nice tight bend radius without kinking and looks great too. This tubing is 7/16" ID by 1/2" OD.
Box full of braid from the scrap bin next-door to where my Dad works (thanks Dad).
Stuff that will be going inside.
Corsair HX750 PSU
Thermochill PA 120.2
2x Scythe Kaze 1900RPM for the rad
D-tek DB1 pump
Intel X25-M 160GB
Where I would like to place the radiator.
Top needs to be raised ~40mm.
The cheap fan controller included in the case front panel uses an LM317 adjustable linear regulator and a 3-way switch. Inefficient design, but it works fine and is actually better than I was expecting.
Here is what I plan for a reservoir in the side-panel. I will be making this out of acrylic or some similar material.
Edited by ARandomOWL - 1/14/12 at 12:36pm
Daily
(16 items) |
|
Daily
(16 items) |
The final placement will be in the front of the case at the top where the 5.25" bays were. Today I made some brackets to fix the radiator + fans.
