Mouse has tracking troubles on multi-coloured pads, If you has small-medium hands it is palm or claw grip mouse. For large handed people only claw, go and buy ec1 if you want to palm.
This is not the first time that I bought these fans, however in an effeort to try and shave some degrees off my load temps, I thought I would give them another go as I was impressed with their...
It is rare to find a company so passionate about their products and attention to detail and quality. Well guys, I think I have finally found one. The Enermax Maxrevo EMR1500EWT is one of those...
Bought one of these a year ago for the shipping desk's computer back when I discovered the love and awesomeness of mech kybds and went on a buying spree for my business. OK, so we average about 10...
These popped up on my radar on Amazon for the stupid low price and I got two for work. One was definitely for the shipping station's computer. Other one? Well 1st was so cheap!! I might go find...
So the first thing I had to do was try the heatshrink out on the tube. It looks VERY nice. The compression is a little hard to get on though....
Realistic ripples
Note: Bmavericks pumps did not work with the screws that came with my res combo. I drilled out the wholes and added washers.
Case after stripping and before the knife.
Here is where the rad is going, for the person that asked. very nice fit.
Far left line is the end of the PSU, right line is the end of the molex connectors (i got a fully modular psu) and there is still plenty of room. The cables will be coming out towards the top of the psu, above the rad.
Cut the 5 hdd bay down to 2, This will fit right under the res/pump.
There will be a door covering the bays, so i can put things right up to the edge of the case.
Oh no... my side latch hits the 5.25 bays.... i can fix that *come here dremel, who wants some metal to chew!*
This will be on the side panel, and there will be a metal catch so it will hold the door shut.
Thanks for looking, and there will be another update later today.
Cutting off the side panel's clips, so it will swing out.
Caselabs hinge... I know it is upside down Jim... but It only works for me this way, for this situation. (pivot is in a working place)
After cutting all this small stuff... i have the fun job of making it clean tomorrow yay..... :/
First latch fitted. The panel will have to be strengthen but the window may help alot.
I have the window and other latch all outlined to cut tomorrow. Also will be cutting the space for rad, and working with the hard drive cage.
Thanks for looking.
I have cut out the rad, window and second latch. The side panel is just the way i want it.
so i got a huge piece of diamond plate for free. It is a little oxidized and there are a few spots that are not usable, but this is still a huge saver.
Rad hole cut and fitted, also the floor is installed. Im waiting on the metal for the drive bay area. This metal will extend all the way down to the floor.
Here is a latch of the lower latch catch.
Ive gotten a little more done but it is more layout things than actual modding.
finished the front door today. Went ALOT better and easier than i was thinking it would have.
Some more (upside down) Caselabs hinges.
It opens!
It works better than i thought. I dont need to make a bracket for the latch to hold onto. It just latches to the bezel itself, and it clears everything and it can just be pulled off with the bezel.