Overclock.net › Forums › Components › Hard Drives & Storage › SSD › Moving Force 3 from SATA2 to SATA3
New Posts  All Forums:Forum Nav:

Moving Force 3 from SATA2 to SATA3

post #1 of 4
Thread Starter 
Been a while since I've had to ask for help...somewhat humbling.

I have a Force 3 120GB that has been a thorn in my side for a long time. When I first got it the only way I could make it stable on my system was to run it in my SATA 2 ports. Well a few firmware updates later and I want to try running it SATA3 again.

However when I move it either to the Intel SATA3 ports or Marvell SATA3 ports I get a boot error: 0xc00000e9
I'm guessing there's an MBR problem or something however Windows 7 Boot Repair can't fix the error and I'm a little rusty on my Dos Prompt commands.


Any help available?
post #2 of 4
Check to see that all the SATA connections are clean. Also, try resetting the CMOS.
post #3 of 4
Thread Starter 
Well I've tried four different ports so it's not dirt and resetting the CMOS can't really help as I have a raid array which I need working. All the other controllers are set for AHCI.
post #4 of 4
I'm pretty sure by resetting the CMOS your RAID array will be fine.

But here try this first. the CMD commands.

http://answers.microsoft.com/en-us/windows/forum/windows_vista-system/status0xc00000e9-mean-on-startup-unable-to-boot/95f6eadd-6adf-4be3-be62-4dfcb2874a50
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: SSD
Overclock.net › Forums › Components › Hard Drives & Storage › SSD › Moving Force 3 from SATA2 to SATA3