Here's the reservoir and custom standoffs I needed to make. They are machined from aluminum which I had laying around. You'll also notice my silver bar. This will be placed within the reservoir. I couldn't see spending 10.00 on a "coil" or sliver of silver. So I decided it would be a better investment to spend 30.00 on 1/2 ounces of silver. It will be mounted in the reservoir via rubber tubing. I'll show that one in later images.
I do want to note, if you want to make it WAY easier to install the reservoir, use the smaller 150mm (maybe 100mm...whichever it is). It will make installation much easier. It was very tricky to mount the reservoir as I have done. (I"m stating this in past tense as this whole post is a re-post from November/December...which I discussed on another forum...which I later deleted for my own personal reasons.
Edited by betatester1 - 2/29/12 at 9:07pm