Update 8 DD/MM/YYYY - 16/12/2006 (ALL PICS ALL CLICKABLE
Ok, have been busy with the wiring of my case. and still had problems with the setup of the 5.25" drive bays cause the look of it just wasn't good enough for me
anyway i started on the managment of my wires, so when i will put all the devices in it it is plug and play
but i didn't expect the complexity of wire managment
This was about already an hour of struggling with the wires (still had to do some sleeving)
The wiring of the KamaMeter
(Fancontroller) i still need to figure out where all the temp sensors go on, i already have cpu temp (on channel 1) and ambient temp (on channel 4)....
btw notice the front bezel is of.... you get 3 bezels with this fancontroller, white, silver and black !
(of cours i'm gonna use black)
the connect this baby up was real easy (the users guide is only 2 pages with info you probably already know
sleeved the 92mm fan-wires, looks real good
The setup for now... i usealy go with one 5.25" drive bay free between the DVD-ROM's because of the heat, but i don't like the look of it, and i still can change it later on. also have decided not to use the tool-box you get with this case cause i'm gonna instal an second Icage (or single fan) there.
all the fingerprints on the case
after 3 hours of work..... still need to do tons of hiding....
as you probably already know, the 'right' side where you can mount the 5.25" drives is one mighty
place to hide your wires (or inverters), i think i can hide about 80 % of my wires there
the 2 remaining temp sensors of the fancontroller (sleeved and well
), you just stick them with some tape or gum (not bubblegum
) to a place you want to read your temp.... if anybody got ideas where to put them to, then shout it out ! comments are always welcome
will be continued !