Originally Posted by Demented
Only marks I made were the first one or two. After that, I realized that I just needed a firm twist right at a clip.
If you are doing it right you get no marks. Make sure you are using a WIDE flat blade screwdriver and pulling the bezel away from the back with decent force so there is plenty of tension. Then once you slide the blade in a small twist is all that is needed to pop the bezel - check the photos closely since if you just rest the blade on the front lip you will mark up the bezel easily. The sides require a little more twist I found. The top and bottom should pull off without using the blade once you get it started.
Originally Posted by NameMakingSux
Here is a question for you guys. If I were to order a crossover would I be able to get one of these pcbs if they become available to OC that? And if we don't know for sure do we speculate that it most likely would?
No idea. I have asked for pictures of the internals for both Achievas and Crossovers and haven't seen any yet (granted I am not out trolling for them either.) If you have seen them, shoot me a PM, no need to clog up the Club with your crappy monitor details!
Just to be clear - here are the four parts necessary to OC (thanks to bQvle for the all-in-one). Working on getting them.