Quote:
Originally Posted by rollOver 
Sounds that way, the red blinking indicates a check power adapter. If you have a multimeter, check the voltage out on the two sets of pins top and bottom should both output at least 24vdc steady, no fluctuations. Be careful not to ground them out with the metal shield around them.

Sounds that way, the red blinking indicates a check power adapter. If you have a multimeter, check the voltage out on the two sets of pins top and bottom should both output at least 24vdc steady, no fluctuations. Be careful not to ground them out with the metal shield around them.
Yep its alternating. 23.5, then 22.6 back and forth. The good one puts out 23.5V solid.
I'll note too, this was the PSU that was running 125-128 degrees F. The other monitor was running about 122 degrees.
I adjusted the brightness yesterday which seems to of lowered the temperature a little, but I didn't get a chance to put a infrared meter on it yet.
Edited by cybercussion - 7/1/12 at 7:13am





















