Quote:
I basically just did this http://www.overclock.net/t/1225919/yamakasi-catleap-monitor-club/7950#post_18008557 I just used gorilla glue to bond my blocks of wood to the back of the panel. As for the debezeling itself, i just followed the teardown guide in the OP of this thread, but just took it a few steps further
I'm using Ergotron Neo-Flex stands also.Quote:
It took off at least an inch. Right now, by overlapping the side panel's bezels behind the center one, i have roughly half an inch of bezel between the panels. It's noticeably easier on the eyes in fullscreen games.




















