Step:0 use this screw set below(detail installation step please see the installation manual)

Step:1 Prepare these two type of screw driver(cross and star type)

Step: 2 detach screws at the back of the board

Step: 3 detach screws at the PCI blacket

Step: 4 stick those ramsink or VRM sink, for VRM sink, the picture is just for your reference only, you can choose other type of VRM sinks inside packaging too.

Step: 5 connect the 4pin to the VGA board or the attached power cable

It will be like this after you installed the REV.2 ICY on GTX680





Edited by tony_choi - 3/27/12 at 11:36pm

Step:1 Prepare these two type of screw driver(cross and star type)

Step: 2 detach screws at the back of the board

Step: 3 detach screws at the PCI blacket

Step: 4 stick those ramsink or VRM sink, for VRM sink, the picture is just for your reference only, you can choose other type of VRM sinks inside packaging too.

Step: 5 connect the 4pin to the VGA board or the attached power cable

It will be like this after you installed the REV.2 ICY on GTX680





Edited by tony_choi - 3/27/12 at 11:36pm



















