I did a quick search before posting (this is normally posted by idots who get shamed in the very next post with a link to the correct answer, be nice
) but i hve an issue with my UD5H Rev 1.1 (i have also posted this on the gig uk forum, but i wanted to hedge my bests for a good answer, or any answer tbh.
so anyways...I bought and build my new machine over the weekend, i had planned to have the following drive config
Boot Drive (Win7)
Crutial m4 256gb mSATA SSD (sata2|Port5) (As required)
then a Raid 5 array consisting of
3tb Seagate Baracuda (sata2|Port2)
3tb Seagate Baracuda (sata2|Port3)
3tb Seagate Baracuda (sata2|Port4)
I switch the bios from ACHI to Raid as instructed (all drives shown in BIOS as possible boot drives), and did a test install to the SSD to ensure all was connected to the system.
Updated the bios (Version F14) so that the Z77 Raid controller could see the 3tb drives (as prior, it was going to a blank screen on the raid controller configuration screen), and set up an Array (Volume0) and assigned the three Seagate drives to it.
Once done, only the Volume0 array appears in the possible boot drives for the bios to boot from.
The SSD can be seen by the controller but not the bios as a boot drive.
Any ideas what switch i have missed to get this working.
Currently have the z77 set to ACHI and a raid 1 set up using the secondary on board raid controller, which is not ideal.