Originally Posted by jivenjune
Well, I got Virtu MVP to finally work. I had to do a complete reinstall since I screwed up my driver installation order.
I pretty much did it in the following order using the drivers on Gigabyte's motherboard website:
1. Windows 7 Installation (Pre-installed Intel Raid Drivers)
2. Intel Management Engine Interface
3. Intel INF Installation
4. Intel Rapid Storage Technology
5. Intel VGA Driver
5. Marvell Sata controller
6. Marvel Storage Utility (I don't think this one is necessary)
7. Intel LAN Driver
8. Atheros LAN Driver
9. Intel USB 3.0 Driver
10. Wireless Drivers
11. Nvidia Drivers (270.?? WQHL)
All of my display outputs are working properly now. I think LucidVirtu MVP has some issues with some more of the recent Nvidia drivers, so I took Sin's advice and rolled some older drivers to much success. I hope this helps anyone else.
Thanks again to Sin for the help and recommendation. This motherboard is awesome (Z77-UD5). Its boot time is significantly faster than its P67 counterparts I used.
Could you please help me out as I am unable to get mvp to install correctly. I keep getting error message "wrong gpu config". I enabled the
iGPU in the bios as per Sin, and plugged my monitor into the igpu on mobo, installed the igpu drivers so now I can get an output using just
the igpu. I have then disconnected from igpu and connected monitor to the dgpu and installed its drivers and can get an output from the
dgpu. I then downloaded mvp from gigabyte site and installed, but keep getting the error message. I assume after you have installed the
igpu that you go back into the bios and switch the setting back to "auto" instead of "igpx". I tried it both ways and same error message. also,
do you have to have monitor connected to both igpu and dgpu at same time?