No point, really.. A calibration is dependent upon your specific monitor and lighting conditions and brightness/contrast settings. I highly recommend just buying a calibration tool. I attached it anyway, just make sure to match these settings on your OSD: Brightness 50, Contrast 70, DCR Off, Backlight 3, and Color Status Management: Normal.
EDIT: WARNING - DO NOT USE THIS PROFILE WITH RECENTLY ISSUED (JUNE OR LATER) MODELS OF THE 2720 MDP - THIS PROFILE WAS CREATED FOR A 'BAD BATCH' MODEL WITH HORRIBLE FACTORY COLORS. USE OF THIS PROFILE WITH A 'FIXED' FIRMWARE MODEL MAY RESULT IN INACCURATE COLOR TEMPERATURE
Crossover 2720MDP-2.2-6500.zip 2k .zip file
Quote:
Highest I can get through the DVI-D is 60Hz, so I doubt it.
Can you try the component input and see if you have any issues?
Edited by pabloedvardo - 6/19/12 at 4:54pm






