Quote:
Originally Posted by
Lutro0 
Oh but its good pain! Or pain well spent anyhow.
Good job~
If you take the time you can do it! Just ask any questions you might have and practice a bit on some spare cables.
Quote:
Originally Posted by
yutzybrian
Dang I want to do the "shrinkless" look so bad with mine but not sure if I can pull it off
Thanks guys.
I had to pull very hard each pins. After 24 wires, you easily get the trick. I am very happy with my job, much better than my first PSU (with single braided sleeve, could see the wire color under)
I am providing more picture of the PCI-E cables for the Lepa G 1600.
(Someone asked)
The PSU Connector has ( 6 x 12v)Yellow + (6 x COM)Black. So it is a 12 Pins connector going into the GPU ( 8 + 8) pins . The Black wires are splitting near the PSU connector going from 3 wires to 5. I used a shrink on each cables then used a bigger shrink to tight everything. I am not sure if its the way to do it, but its the way I did it and I think it the best I could do with that type of extensions.
Three black wires splitting into five. Twice. (Their is 6 yellow wires at the PSU but also 6 at the PCIe connectors so 10 Blacks)
On this one I missed a little bit but you can understand how I proceeded. I used 8 x 1/2" Shrinks (or 1/4") and one big one to wrap everything. I would say around a 1 inch shrink.
On and Teaser, swapped my fans for some Corsair AF series. Just ordered 4 x 7970 with EK Nickel/Acetal water Block with Quad bridge. Will also receive some work from Dwood soon.
Sorry I have bad lighting when its night in that room.
Edited by KaRLiToS - 6/27/12 at 5:47am
