undervolting my 3930K - Page 2

I would try to change the TIM, may be it's not seated properly.
An h100 should handle overclocks with this CPU.

On a side note, I juste checked razer website for that wallpaper and couldn't find it
Edit : Google found it

Read first mang

http://www.overclock.net/t/1189242/sandy-bridge-e-overclocking-guide-walk-through-explanations-and-support-for-all-x79-overclockers/0_30

haha no worry thanks anyway !

Did you run prime95 for a few hours on it ? Stay about 30 minutes near your computer and watch your temp, if they are near 60 leave it there for 12 hours if they are 65-70 stay close and watch them (You don't want to burn your chip).

those temps are bad for an H100... i get the the same temps with my Cooler master hyper 412 @ 4.4 with my 3930k

as others have said remove the cooler, reapply TIM and reseat the waterblock.

What kind of temps do you get running prime95?

I just get really high temps with my H100 in a Carbide 500R, with all fans to the MAX.
I get 74 degrees (ambient temp is 23) for 4.375GHz using CPU strap of 125*35, and voltage of 1.28 (I'll try to lower it a bit, that should be possible). And I reseated the pump twice with Noctua NT-H1 thermal paste, I tried all possible configuration (rad inside or outside, 2 stock fans pull or push), I just can't go lower... The rad stays really cool, fan spin to the max (it's amazingly noisy...) and still I get bad temps.

When you guys say that those temps around 60-65 are bad, I just cry...
There must be something wrong in my setup, any idea?

EDIT: I managed to go to 1.25V (lower is impossible) with a max of 70 degrees. That's the best I can do with my H100...
Edited by karakistou - 6/1/12 at 5:22pm