Well it seems i've hit a bump...
The zalman z9 case comes with 4 fans 1 on top 1 on the back and 1 on the front and one on the side.
I have the top fan plugged into the mobo on cha_fan.
Which is great and all but the mobo only supports the cpu fan and that 1 channel.
The back fan is a Big 4 pin Peripheral connector with 2 black wires going into the back.
It looks as if i can plug something into the back of it and then plug it into something in the front.
While the others have a 2 pin connection.
The case also has a temp monitor, i plugged all the small cables into the mobo,
Pwr and ground
I believe this is correct per manual diagram.
Is it possible to have all the fans hooked up or what shall i do?
do both fans just plug right into the two 2 pin connectors?
and the big 4 pin connect to the red/black peripheral connection coming from the PSU.
If not/if so what about the two 4 pin conectors for the fan controller?
So essentially their are three 4 pin connectors coming from the case 2 from the front panel, and the pin from the back fan
Does this look even remotely close to being right?
The Power supply connection on the left is going into the back fan connection 2 black wires???
While the one on the right, the power supply cable is GOING into both of the front panel connectors.
Here is a better picture of what i'm dealing with for better or worse clarity.
Is this correct?
Any help would be greatly appreciated. Thanks guysEdited by JokersAce - 6/12/12 at 8:39pm