Seasonic SATA Power Adapter Movement GuideStep 1: Remove existing heatshrink and sleeving
Cut the heatshrink.
Peel the heatshrink/sleeving back.
Use snips or scissors to cut the remaining sleeving and heatshrinkoff.Step 2: Take power adapter off wire
Push connector as near to 90 degree to the wire as possible.
Insert flathead screwdriver under adapter cap. Run along length to remove cap.
Remove wires one at a time from adapter. Wiggle to create slight gap between adapter and wire, use small screwdriver, toothpick, knife, etc to push wire out if needed. Otherwise grab both sides of the wire on each side of adapter and pull.
Done.Step 3: Insert removed adapter into wire where desired
Insert removed adapters into SATA drive power slots installed in case for proper measurement.
Install one wire gently into adapters. I prefer red because it is in the middle, but really any work.
Remove adapter from SATA drive and press wire in using flathead screwdriver.
Repeat for each drive/SATA device needed.
Install remaining wires, be sure to do so in the right order
Trim wire endings to desired length. To make them flush it is easiest (in my opinion) to use a razor blade or something similar.Zip tie multiple wires to improve cable management. Hope this helps!