Hey guys. Wanted to let you guys know what I found with my pci-e cables.
While sleeving one of them, I noticed that one of my colors got off meaning it went to a hole that the other side hadn't. What I did was break out the multimeter and the other stock cables. What I found was that all three cables were aired different.
Basically, the yellow wires on the 12 pin correspond to each of the other connectors. Looking at the right or left side of the 12 pin, there are three yellow wires on each side. The far right yellow wire on the right or left side goes to the far right hole of the video card end. Middle to middle and left to left.
Any of you guys with multimeters, could you check your cables with the continuity setting?


While sleeving one of them, I noticed that one of my colors got off meaning it went to a hole that the other side hadn't. What I did was break out the multimeter and the other stock cables. What I found was that all three cables were aired different.

Basically, the yellow wires on the 12 pin correspond to each of the other connectors. Looking at the right or left side of the 12 pin, there are three yellow wires on each side. The far right yellow wire on the right or left side goes to the far right hole of the video card end. Middle to middle and left to left.
Any of you guys with multimeters, could you check your cables with the continuity setting?





![Intel(R) IPP JPEG encoder [7.0.1041] - Jul 19 2011;](http://cdn.overclock.net/2/22/50x50px-ZC-22e17e54_Picture115.jpeg)
![Intel(R) IPP JPEG encoder [7.0.1041] - Jul 19 2011;](http://cdn.overclock.net/c/cc/50x50px-ZC-ccd1d949_Picture114.jpeg)

















