Overclock.net › Forums › Components › Mice › Razer Taipan
New Posts  All Forums:Forum Nav:

Razer Taipan - Page 14

post #131 of 840
Can you test for acceleration/effects of dynamic DPI scaling?
post #132 of 840
Yeah try CS:S with raw input enabled.
post #133 of 840
I want it and will get it later this summer. I need a new mouse mat that's all biggrin.gif
post #134 of 840
Quote:
Originally Posted by Riou View Post

Yeah try CS:S with raw input enabled.

Mind elaborating? I'll try it out for you once I understand what you're asking for.
post #135 of 840
Acceleration test: load up and spawn into your css map.

Aim at a local fixture can be anything (this is just to make it easier) and ensure your mouse is positioned exactly at the end of your mousepad (point A). Shoot a couple rounds (to see the bullet decals, again to make this easier) then swipe the mouse to the other exact end of the mousepad (point B) fairly quickly. Now swipe the mouse back from B to A slowly. Does the cursor align with the bullet decals? If not - most likely acceleration somewhere or maybe swipe distances were skewed.

Alternatively you could swipe from A to B quickly, fire a few rounds at B to see the decals, then put your mouse back at A exactly where the original decals were then again swipe slowly from A to B comparing where the cursor lands in relation to the bullet decals.

CSS with direct input generally removes acceleration on the software side of things, leaving hardware.
Edited by end0rphine - 6/27/12 at 12:06am
post #136 of 840
Yup, what end0 said.
post #137 of 840
I would like a picture of the calibration tab if you can.
Quote:
Originally Posted by end0rphine View Post

Can you test for acceleration/effects of dynamic DPI scaling?

Don't think there is any. (Dynamic DPI Scaling)
post #138 of 840
From the unboxing video it seems to me it's the same optical sensor on top like on the on the Imperator/Mamba 4G, which leaves the bottom sensor as the one being the laser sensor. This means no PTE in there.
post #139 of 840
Quote:
Originally Posted by MONVMENTVM View Post

From the unboxing video it seems to me it's the same optical sensor on top like on the on the Imperator/Mamba 4G, which leaves the bottom sensor as the one being the laser sensor. This means no PTE in there.

The optical sensor from the 4G mamba and Imperator is an S3888. I highly doubt that will fit.
post #140 of 840
Quote:
Originally Posted by Skylit View Post

I would like a picture of the calibration tab if you can.
Don't think there is any. (Dynamic DPI Scaling)

433
Edited by JonnyBigBoss - 6/27/12 at 9:55am
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Mice
Overclock.net › Forums › Components › Mice › Razer Taipan