Oh do I have a treat for you guys today! Got lots of pictures, and HIGH quality ones too. Borrowed my girlfriends camera today. Got a lot of work done too. Here we go....UPDATE 4 - Painting
So today I finally epoxied the holes on the case, sanded it down and painted the inside. I also painted the PSU housing.
So today's priority was to fill those holes on the inside of the case, and clean it!
Close up of holes.
All clean! Or mostly clean I guess.
Filling holes with epoxy.
Spread out evenly or the best I could. I'm not quite sure if this was the right stuff to get...
My ghetto paint booth! It actually worked quite well.
First coat of primer. This stuff was old and it sucked or I didn't do something right but I didn't like how it was covering the metal.
While the primer was drying I went and sanded down the first filling of the holes. Boy was that a bear...
So I decided that that sanding job looked like poop so I worked even harder and it looked much better.
Second filling of epoxy.
First coat of paint on the PSU housing.
Epoxy has dried and is ready for sanding (again).
Sanded with 100 grit.
Sanded with 400 grit.
Prepped for paint!
First coat of paint.
After second coat of paint. That was all I had time for today. I might hit it up with another coat of paint tomorrow depending on how it came out.
And that's all of today's work! I hope you enjoyed the pictures! As always, post your comments/questions/concerns! Thanks!