Overclock.net › Forums › Case Mods & Cases › Computer Cases › ZALMAN Z11 CLUB
New Posts  All Forums:Forum Nav:

ZALMAN Z11 CLUB - Page 16

post #151 of 1124
Hey guys! I want to add one intake fan at the bottom and another exh. fan on top the problem is the vibration how can i lessen it?should I buy adapters to lessen it's fan speed?
post #152 of 1124
Quote:
Originally Posted by xplusy View Post

Hey guys! I want to add one intake fan at the bottom and another exh. fan on top the problem is the vibration how can i lessen it?should I buy adapters to lessen it's fan speed?

I shouldn't be loud at all or vibrate, I would remove it and check it, also press it firmly with your hand to make sure its on the shaft of the motor good. also make sure there not loose because if they are they can make noise, you want to tighten them not loosen. Otherwise you can get quiet fan kit, where it replace the screw with rubber inserts
post #153 of 1124
Quote:
Originally Posted by xplusy View Post

Hey guys! I want to add one intake fan at the bottom and another exh. fan on top the problem is the vibration how can i lessen it?should I buy adapters to lessen it's fan speed?

I think a couple Zalman Zm-F3 FDB's would do you good. They're a good value. They are very quiet and strong and come with rubber mounts and a resistor. They are right around 12-14$ Oh and they look gorgeous in my case.

http://www.newegg.com/Product/Product.aspx?Item=N82E16835118069
Edited by tyguy - 2/17/13 at 6:05am
post #154 of 1124
Quote:
Originally Posted by MCCSolutions View Post

I sold that one with the case, If I haven't I would send it to ya thumb.gif But im sure you can make one, just find a old case and measure and cut, add a l bracket at the rear of it for stability and support, sand the edges and apply a few coats of paint then bake at 170 degrees for a hard finish


Well I appreciate it nonetheless! Hmmm I do have a couple extra cases around these parts. Thanks for the directions! Sounds easy enough. biggrin.gif
post #155 of 1124
SO another question hahaha
About my CPU temperature
My Specs are:
i5-2320 3.0ghz
4gb DDR3 Biostar GPU
PH861mlx MOBO
My inquiries are:
My CPU Temperature can go up to 43-45C with the stock cooler and my gpu goes up to 38-40C with the Zalma Z11 Case.is it just a normal temperature? If I will buy extra 2 fans for bottom intake and top exhaust will it lower the temperature greatly, by how much? and also if I will change my cpu cooler to a third party one will it lower my cpu temp greatly?
post #156 of 1124
Quote:
Originally Posted by xplusy View Post

SO another question hahaha
About my CPU temperature
My Specs are:
i5-2320 3.0ghz
4gb DDR3 Biostar GPU
PH861mlx MOBO
My inquiries are:
My CPU Temperature can go up to 43-45C with the stock cooler and my gpu goes up to 38-40C with the Zalma Z11 Case.is it just a normal temperature? If I will buy extra 2 fans for bottom intake and top exhaust will it lower the temperature greatly, by how much? and also if I will change my cpu cooler to a third party one will it lower my cpu temp greatly?

That is abnormally low actually. Unless those are idle temperatures, in which case they are too high. What are you using for temperature monitoring? If those are your normal operating temperatures you are doing just fine.
post #157 of 1124
BTW during BIOS setup I monitored the temperature and got 39-44C, is ti that bad?should I call for help from where I bought it? Thank you
Edited by xplusy - 2/19/13 at 1:06am
post #158 of 1124
While I'm playing LOL with 60fps smoothl I have my current temp from HW info shows 45-47C. I will have someone fix my cable to have better airflow this week end and add two fans, my goal is to decreasy my temps at least 5C. I'm planning to buy air cooler from cooler master I don't know if I'll buy the V8 or GT V6 or i'll just save it and buy water cooling Corsair H series?
Edited by xplusy - 2/19/13 at 3:48am
post #159 of 1124
Thread Starter 
Guys, remember that a cpu cooler (for example the scythe mugen 2) is a big metal thing thatneeds to be hot for about 30 degrees, why they put a fan on it?
This is for simply move the hot air that are on the blades and on the heat pipes, what you need to do is put a back fan on the case and another one or even two on the top and let them aspire the hot air.
My temps are in idle for about 30°C , while I am gaming, I don't know... I'll play now to see

54°C while playing on MW3 for the CPU and 78°C O___o for the GPU


NEW ! http://youtu.be/JazAqlFeMZc
Edited by GTX670 - 2/22/13 at 7:56am
Digitalizeur
(24 items)
 
  
CPUCPUCPUMotherboard
Intel® Core™ i5-3570K Intel® Core™ i7-4790 ASUS Z97-PRO MSI® Z77A-GD65 
GraphicsGraphicsRAMHard Drive
MSI® N670GTX OVERCLOCKED (REFERENCE) MSI® N670GTX OVERCLOCKED (REFERENCE) Kingston® HyperX™ Genesis™ Samsung® 840 EVO 250GB 
Hard DriveHard DriveOptical DriveCooling
Seagate® Barracuda™ 7200.12 Seagate® Barracuda™ 7200.14 Sony® Optiarc® AD-5280S-0B Scythe® Mugen™ 2 (REV_B_2100) 
OSMonitorKeyboardPower
Microsoft® Windows® 8.1 Professionnal x64 6.3 (... ASUS® VE248H Razer® BlackWidow™ Ultimate™ 2013 (AZERTY) SilverStone® Strider Gold Evolution 2.0 (80+) 
CaseMouseMouse PadAudio
ZALMAN® Z11 Plus (USB_3.0) Logitech® G500s™ Razer® Goliathus™ Extended (Speed_Edition) Logitech® Z623 (2.1_130Wsub_35W+35Wsat) 
OtherOtherOtherOther
Cooler Master® BC 120 Blue-LED Cooler Master® BC 120 Blue-LED SilverStone® CP-09 (USB_3.0_ADAPTER) SilverStone® PP-06 (SLEEVED_CABLES) 
  hide details  
Reply
Digitalizeur
(24 items)
 
  
CPUCPUCPUMotherboard
Intel® Core™ i5-3570K Intel® Core™ i7-4790 ASUS Z97-PRO MSI® Z77A-GD65 
GraphicsGraphicsRAMHard Drive
MSI® N670GTX OVERCLOCKED (REFERENCE) MSI® N670GTX OVERCLOCKED (REFERENCE) Kingston® HyperX™ Genesis™ Samsung® 840 EVO 250GB 
Hard DriveHard DriveOptical DriveCooling
Seagate® Barracuda™ 7200.12 Seagate® Barracuda™ 7200.14 Sony® Optiarc® AD-5280S-0B Scythe® Mugen™ 2 (REV_B_2100) 
OSMonitorKeyboardPower
Microsoft® Windows® 8.1 Professionnal x64 6.3 (... ASUS® VE248H Razer® BlackWidow™ Ultimate™ 2013 (AZERTY) SilverStone® Strider Gold Evolution 2.0 (80+) 
CaseMouseMouse PadAudio
ZALMAN® Z11 Plus (USB_3.0) Logitech® G500s™ Razer® Goliathus™ Extended (Speed_Edition) Logitech® Z623 (2.1_130Wsub_35W+35Wsat) 
OtherOtherOtherOther
Cooler Master® BC 120 Blue-LED Cooler Master® BC 120 Blue-LED SilverStone® CP-09 (USB_3.0_ADAPTER) SilverStone® PP-06 (SLEEVED_CABLES) 
  hide details  
Reply
post #160 of 1124
For those of you with this case and the H80i where did you mount the radiator? I can't exactly mount it on top because of my mobo. I have the MSI MPower Z77. The heatsinks on it get in the way.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Computer Cases
Overclock.net › Forums › Case Mods & Cases › Computer Cases › ZALMAN Z11 CLUB