Overclock.net › Forums › Volt Mods › General Volt Mods › Graphics Cards Volt Mods › vmoded hd4650 and what software i must use for clocking
New Posts  All Forums:Forum Nav:

vmoded hd4650 and what software i must use for clocking - Page 3

post #21 of 35
7/9/12 at 1:55pm
Thread Starter 
1,26v vgpu
Reply
Reply
post #22 of 35
7/9/12 at 2:08pm
That's fine! You can start the fun part now! OC it, if you're not happy with the clocks raise the volts by turning the VR clockwise and monitor the voltage. Volts can jump up quickly so be careful. Try not to go over 1.45v cuz that will just give you heat and can damage the card long term. Keep and eye on the temperatures! More volts = more stability, more heat = less stability. Try to find a sweet spot for 24/7 use.
Lastly, show us the results.
Good Luck! thumb.gif
Reply
Reply
post #23 of 35
7/12/12 at 6:04pm
Thread Starter 
if i turn these vr clockwise it dont increase voltages
Reply
Reply
post #24 of 35
7/13/12 at 2:16am
What? You're saying nothing happens if you turn it? Both of them?
Reply
Reply
post #25 of 35
7/13/12 at 2:20am
Thread Starter 
yes, nothing happens and voltage stay same level
Reply
Reply
post #26 of 35
7/13/12 at 2:23am
Even if there is no resistance between those 2 points? (if the VR is close to 0OHM or 0OHM)
Reply
Reply
post #27 of 35
7/13/12 at 2:56am
Thread Starter 
???
Reply
Reply
post #28 of 35
7/13/12 at 3:28am
So... mem voltages and core voltages aren't changing if you turn the VRs? How many turns did you make?
Reply
Reply
post #29 of 35
7/13/12 at 3:35am
Thread Starter 
2-3
Reply
Reply
post #30 of 35
7/13/12 at 3:52am
Try turning some more... and monitor the volts.
If it doesn't change turn counterclockwise.
Reply
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Graphics Cards Volt Mods
Overclock.net › Forums › Volt Mods › General Volt Mods › Graphics Cards Volt Mods › vmoded hd4650 and what software i must use for clocking