Quote:
Originally Posted by FtW 420 
depends on the gpu, there can be cold bug & cold slow issues with some (cold slow is where the framerate can drop from say 100 fps to 10 fps when hitting lower temps, fermi does this but g92 shouldn't). Ivy can be buggy too although much lower temps than sandy, down around -100° you might have to up the bclk a bit to boot colder, I was booting full pot with 105 bclk.
depends on the gpu, there can be cold bug & cold slow issues with some (cold slow is where the framerate can drop from say 100 fps to 10 fps when hitting lower temps, fermi does this but g92 shouldn't). Ivy can be buggy too although much lower temps than sandy, down around -100° you might have to up the bclk a bit to boot colder, I was booting full pot with 105 bclk.
yeah ive def been reading a lot about booting 105+ bclk for full pot.
so heres the LET job i just did on the top of card.. maybe a second coat is in order? or should this be sufficient? im thinking about using some eraser around the edges of the actual gpu before mounting the pot.. thoughts on that? also, what about the little tiny resistors surrounding the core, embedded onto the gpu?
Edited by michaelrw - 7/8/12 at 7:09pm
HWBOT pwnage
(24 items) | 
| 
Extreme OC
(52 photos) |
|
HWBOT pwnage
(24 items) |
|
Extreme OC
(52 photos) |
