Originally Posted by renzkuken1
I'm getting so pissed off~~!
I can't even open the stupid process in artmoney pro (i payed a few bucks to get it....)
It says cant open msi afterburner process.
I'm struggling so hard to get it open in a memory editor to increase the voltage past +93mv....
Any help much appreciated. Oh and michaelm can you please add me to the spreadsheet on page 1.
-Download ArtMoney SE v7.39
-Open Afterburner 2.2.3
-Right-click ArtMoney and select Run as Admin, then click continue
-Select Afterburner from the drop-down list in the center
-Set the core voltage (or any voltage you want to 'edit') in Afterburner to a number other than +0 (just to help narrow results) and click Apply. For this example, we'll assume you set the core voltage to +31mv
-Click Search in ArtMoney and enter 31 in the value box and then click OK, then click OK again
-Change that same voltage in Afterburner to another number, we'll say +63mv, then click Apply
-Click Filter in ArtMoney and change the Value box to the new voltage value you just applied in Afterburner and click OK, then OK again
-Click the top arrow in ArtMoney to move the top value listed in the left column to the right column (If you did the search and filter correctly, then the addresses for each voltage you should have come up with depending what you were editing are- Core = 00449000, Memory = 00449030, Aux = 00449060)
-Once you moved one of those into the right column, right-click it and go to Set Value, enter the voltage off-set you would like, then click OK, and notice that it's changed in ArtMoney
-Now, change one of the clock speeds so that you are able to click the Apply button in Afterburner, and then click it. You will now see the edited voltage jump to the amount you entered in ArtMoney
BE CAREFUL WHAT YOU ENTER. Make sure the voltages in Afterburner jumped to where they were supposed to before you put any type of load on the card
These are the directions where I get specific, because I remember having problems as well so I put in most of the things that I was doing wrong but eventually got some help with it with from everyone. You should not have had to pay anything. It sounds like you're skipping the step that says "right-click and choose 'Run as Administrator'". If you don't do that then it won't work. Do everything word for word and you should be all set.
Sorry you had to pay for it though. Don't be afraid to ask questions. I know I'm not, ha. But yeah follow those and you should be set.