Making all new cables next week and was thinking of making a new cable solely for the second EPS connection (second is a 4 pin). There are obviously adapters to convert molex to EPS but I figured I would skip the adapter and just make one.
I am currently using the second one that comes with the PSU but it eats up the second PCI connector slot.
I figure this should be just fine given the wattages/amperages needed and what the AX750 can supply. But I just thought I would bounce it off of you guys before I go ahead and make it.
Current setup:

Desired setup although probably swap the hard drive and custom EPS cable, but this general idea:

Thoughts, ideas, concerns?
I am currently using the second one that comes with the PSU but it eats up the second PCI connector slot.
I figure this should be just fine given the wattages/amperages needed and what the AX750 can supply. But I just thought I would bounce it off of you guys before I go ahead and make it.
Current setup:

Desired setup although probably swap the hard drive and custom EPS cable, but this general idea:

Thoughts, ideas, concerns?













