Originally Posted by windsurfdoctor
Hi, thanks !
Yes, I tried with 1.187 but running throug various combinations I can´t remember any results
I edited only left 3 power fields.
I just reflashed with stock BIOS and the best stable I can get is 1200/7000 (Heaven 4.0 reads 1330 Mhz but that must be a mistake.... I wish it isn´t though
And what is the difference between "Max table clock" and "Boost limit" ? I always set them to the same value...
Ok, so voltage is not really helping much with memory set to 7000 , you need to drop it back to 6300 to get higher core clocks .
I asked about power cause it seems real high ,you have 195 as 100% and 285w for max . Does it go to 70-90% when running BM ?
I guess it ok just seems extreme high , normally 250w or so is plenty .
what were the stock values of 100% and max power on left side ?
I am no expert on this but boost limit is max the card will clock to under boost w/o 3rd party app . the max table clock is just that, it sets all the clock steps that are available . Most all the bios i have seen run limit boost =max table boost and i would go with that . It might be fine to run limit lower than table but then you are losing some clock table steps , so think they should be same or not to far off .
Is this a standard 680 with 2gb of mem or its a 4gb one ?Edited by Edkiefer - 5/26/13 at 5:15am